ECU Flasher ECU Tuning Programming Tools for T\o\yota/Le\x\us READ WRITE Via Internal 20 Pin or 26 Pin Connector

New ECU Flasher Tool For Toyota / Lexus Read Write ECU Programmer For Denso and Fujitsu Ten ECUs Support 2015+ With NEC Chip

Description:

For Toyota Flasher, a joint project by Autokey and P.C.M.flash, is a multipurpose programmer for Denso and Fujitsu Ten ECUs with NEC processors installed For TOYOTA/LEXUS/SCION vehicles with petrol and diesel engines through JTAG interface. OBD writing via CAN bus is supported. It is a unique solution in the chip tuning world. It covers almost all the models beginning from 2003-2004. It can read, flash, clear, verificate internal flash memory of microcontrollers if connected to the appropriate connector on the ECU circuit board.

Advantages:

·Its own hardware interface allows to avoid all compatibility and driver problems;

·Work through built-in 20 or 26 pin JTAG connector;

·Full access to the ECU memory at high speed of more than 100 KB/s;

·Saving files in the open format;

·Firmware checksum verification and recalculation.

·SUPPORT 2015 + OBD WRITE and SOME MODELS 2015 + OBD READ

·can READ and WRITE via internal 20 pin or 26 pin connector. connection diagram for all known

Supported ECUs:

For TOYOTA DENSO ENGINE CONTROL MODULE based on NEC 7F00XX series MCU :

76F0038

7F0038A

76F0039

76F0039A

76F0040

76F0040A

76F0070 BGA

76F0085 BGA

saving in normal mode without any master-slave.

master only.

auto CHECKSUM CORRECTION support

These processors were introduced at the beginning of CAN support and as a rule with coachwork change.

Package List:

1pc*Host device of forToyota forLexus Denso ECU Flasher
1pc*12V/3A power out
1pc*16pin cable for ecu reding by OBD
1pc*cable for BDM function
1pc*adapter for mitsubshi reading by boot
1pc*USB cable to connect the tool to computer
1pc*adapter
pcs*pins
1pc*Suitcase

ট্যাগ:

RH850 Prog মাল্টি-প্রোগ প্রোগ্রামার

ECU গিয়ারবক্স মাল্টি প্রোগ প্রোগ্রামার

এমকিউবি৪৮ লাইসেন্স মাল্টি-প্রোগ প্রোগ্রামার